Cost calculator
Asphalt Driveway Cost in Georgia
Georgia installed pricing runs $6.44 to $13.80 per square foot — about 8% below the national average. Enter your driveway size for a local estimate.
Your project
Tight, steep or long-haul sites cost more because the paver and trucks work slower.
Estimated Georgia driveway cost
$3,091 – $6,624
- Area
- 480 sq ft
- Most likely price
- $4,416
- GA price per sq ft
- $6.44 – $13.80
- Asphalt required
- 8.7 tons
- Demolition included
- None
Prices are national planning averages. Asphalt is tied to crude oil and freight costs, so your local quote can land well outside this range. Always confirm with a paving contractor before budgeting. Most Georgia contractors also apply a mobilisation minimum of roughly $1,840.
The shareable link reopens this calculator with your exact inputs.
Asphalt driveway prices in Georgia
A new asphalt driveway in Georgia typically runs $6.44 to $13.80 per square foot installed, with most homeowners landing near $9.20. That puts GA about 8% below the national average.
Strong plant coverage around Atlanta and low rural labour costs keep prices down.
A standard two-car driveway of 600 square feet therefore costs roughly $3,864 – $8,280 in Georgia, and a 1,000 square foot driveway roughly $6,440 – $13,800.
Southern Heat build spec for Georgia
Georgia sits in a Southern Heat zone, where the pavement is attacked by red clay that holds water, heat and heavy summer rain. Red clay subgrade holds water — base compaction is where Georgia driveways succeed or fail.
That translates into a concrete specification: 6 inches of graded aggregate base, normally crushed granite GAB, under the asphalt. On the mix side, PG 67-22 with a 9.5 mm surface mix.
The practical paving season in Georgia is March through November. Plants close outside that window in most of the state, and asphalt placed on frozen or saturated subgrade will not compact properly no matter how good the crew is.
What moves the number most
Three things dominate: demolition of whatever is there now, base depth, and access. Tearing out old concrete adds roughly $2.76 per square foot in Georgia. Difficult access — steep grades, tight gates, hand work around obstacles — adds about 25%.
Thickness matters less than people expect. Going from 2" to 3" of surface course adds only about 8% per inch to the total job, because mobilisation, grading and base are the same either way. It is nearly always worth paying for.
Getting quotes in Georgia
Get three written quotes and make each one state compacted asphalt thickness, base material and base depth, and whether the price includes demolition and haul-off. A quote that only lists a square-foot price is not comparable to one that specifies 3" over 8" of processed gravel.
Book early in the season. Georgia crews fill their schedules fast and late-season work gets rushed into cold weather, which is when compaction problems appear.
Paving costs across Georgia
Pricing inside Georgia is not uniform. The asphalt paving market is set by the metro areas — Atlanta, Savannah, Augusta and Columbus — where crew wages, disposal fees and permit costs all run above the state average. Rural counties in Georgia typically come in 10 to 20 percent below the metro figure on material-led work, and rather more than that on labour-led work, though long haul distances can claw some of it back.
Contractors working in Georgia are licensed or registered through the Georgia State Licensing Board for Residential and General Contractors. Before you sign anything, look the company up there and confirm the licence is current, then confirm liability insurance and workers' compensation directly with the insurer named on the certificate. A licence lookup takes two minutes and is the single most useful check a homeowner can make.
Metro Atlanta counties require land-disturbance approval once you exceed a set area of new impervious surface.
What a asphalt driveway costs in each part of Georgia
Inside Georgia, Atlanta is the market that sets the top of the range — crews there carry higher wages, disposal fees and permit costs, so a Atlanta job typically lands around 8 percent above the statewide figure. Work the same job out into rural Georgia and you can expect roughly 14 percent below it, provided the site is not a long haul from the nearest asphalt plant. Haul distance is the one thing that can reverse the discount entirely: past about 30 miles the truck time starts to eat the saving.
Quotes inside one metro still vary by 30 to 40 percent between contractors for the same scope, which is why the range above is a range. The cheap quote is usually cheap for a stated reason — thinner base, no compaction testing, no haul-off, or a crew squeezing you in at the end of the season. Ask each bidder to price the same written specification and the spread narrows dramatically.
Repair, resurface or replace in Georgia
Resurfacing costs roughly $2.76 to $6.44 per square foot in Georgia against $6.44 to $13.80 for a full replacement, so an overlay is about 40 percent of the price of starting again. That makes it the right call when the base is sound and the damage is surface level: oxidation, minor alligatoring, shallow ruts.
It is the wrong call when the failure is structural. Potholes that come back in the same spot, edges crumbling inward, or soft areas that flex under a car all say the base has failed, and red clay that holds water, heat and heavy summer rain in Georgia is exactly what causes that. Paving over a failed base buys two or three years and you pay for the tear-out anyway. The honest break-even: if more than about a quarter of the surface shows base-related failure, replace it.
Maintenance is cheap by comparison. Crack filling at $0.92 to $2.76 per linear foot and sealcoating every three to five years will take a Georgia driveway from a ten-year life to twenty, and both are a fraction of one percent of the replacement cost per year.
How Georgia compares with neighbouring states
Alabama, South Carolina price below Georgia on the same specification, while Florida, North Carolina run higher. That matters if you live near the line: a contractor licensed in both states will often quote the cheaper labour market and travel, though anything more than about 45 minutes from their yard gets loaded back into the price.
Do not let the border tempt you past the licensing question. Whoever you hire must be licensed or registered to work in Georgia specifically — the Georgia State Licensing Board for Residential and General Contractors is where you check that, and a licence in the neighbouring state does not carry over.
Georgia driveway cost by size
Installed price range at $6.44-$13.80 per sq ft, 3" asphalt over base, no demolition.
| Driveway size | Typical dimensions | GA installed cost |
|---|---|---|
| 400 sq ft | 20 x 20 ft — one car | $2,576 – $5,520 |
| 600 sq ft | 20 x 30 ft — two cars | $3,864 – $8,280 |
| 1,000 sq ft | 20 x 50 ft — two cars plus turnaround | $6,440 – $13,800 |
| 1,500 sq ft | 12 x 125 ft — long rural drive | $9,660 – $20,700 |
| 2,500 sq ft | Large drive with parking apron | $16,100 – $34,500 |
Other paving work in Georgia
| Work | GA price per sq ft |
|---|---|
| New asphalt driveway | $6.44 – $13.80 |
| Resurfacing / overlay | $2.76 – $6.44 |
| Tear-out and haul-off | $0.92 – $3.22 |
| Sealcoating (two coats) | $0.14 – $0.32 |
| Recycled asphalt millings | $1.84 – $4.60 |
Georgia asphalt driveway cost by metro area
Metro figures are the statewide installed range scaled by local labour, disposal and permit costs. Planning estimates, not quotes.
| Market | Installed per sq ft | 600 sq ft | 1,000 sq ft |
|---|---|---|---|
| Atlanta metro | $6.96 – $14.90 | $4,173 – $8,942 | $6,955 – $14,904 |
| Savannah metro | $6.76 – $14.49 | $4,057 – $8,694 | $6,762 – $14,490 |
| Augusta metro | $6.63 – $14.21 | $3,980 – $8,528 | $6,633 – $14,214 |
| Columbus metro | $6.57 – $14.08 | $3,941 – $8,446 | $6,569 – $14,076 |
| Rural Georgia | $5.54 – $11.87 | $3,323 – $7,121 | $5,538 – $11,868 |
Georgia repair and maintenance prices
GA rates for work on an existing surface, before any mobilisation minimum.
| Job | Unit | GA price |
|---|---|---|
| Crack filling (hot rubber) | per linear ft | $0.92 – $2.76 |
| Pothole patch | each | $110 – $368 |
| Sealcoating, two coats | per sq ft | $0.14 – $0.32 |
| Edge or apron repair | per sq ft | $5.52 – $12.88 |
| Resurfacing / overlay | per sq ft | $2.76 – $6.44 |
| Tear out and replace | per sq ft | $7.36 – $17.02 |
Driveway cost in states bordering Georgia
Installed price per square foot, same specification, at each state's own rate.
| State | Installed per sq ft | 600 sq ft job |
|---|---|---|
| Florida | $6.65 – $14.25 | $3,990 – $8,550 |
| Alabama | $6.30 – $13.50 | $3,780 – $8,100 |
| Tennessee | $6.44 – $13.80 | $3,864 – $8,280 |
| North Carolina | $6.58 – $14.10 | $3,948 – $8,460 |
| South Carolina | $6.37 – $13.65 | $3,822 – $8,190 |
Frequently asked questions
+How much does an asphalt driveway cost in Georgia?
Between $6.44 and $13.80 per square foot installed, so a typical 600 sq ft two-car driveway runs $3,864 – $8,280. Demolition of an existing surface is extra.
+Is asphalt cheaper than concrete in Georgia?
Yes — asphalt typically costs 40-50% less to install than concrete. Concrete lasts longer with less maintenance, but asphalt is faster to install, easier to repair and far more forgiving of ground movement.
+When is the best time to pave in Georgia?
March through November. Booking early in that window gets you better crews and better compaction weather than a late-season rush job.
+How thick should the gravel base be for a driveway in Georgia?
Because of Georgia's red clay that holds water, heat and heavy summer rain, contractors here specify 6 inches of graded aggregate base — typically crushed granite GAB. Skimping on the base is the single most common cause of premature failure in a southern heat climate.
+What type of asphalt mix is best for Georgia?
In a Southern Heat zone, the right spec is PG 67-22 with a 9.5 mm surface mix. Ask any contractor to name the binder grade on the quote — if they cannot, they are buying whatever the plant has running that day.
+What goes wrong with driveways in Georgia?
The local failure driver is red clay that holds water, heat and heavy summer rain. That shows up as edge cracking and settlement within three to five years when the base is thin or drainage was never graded away from the slab.
+How long will an asphalt driveway last in Georgia?
15-25 years with sealcoating every 3-5 years and prompt crack filling. In a Southern Heat zone, red clay that holds water, heat and heavy summer rain shortens that to under 10 years if maintenance is skipped.
+Do I need a licensed paving contractor in Georgia?
The Georgia State Licensing Board for Residential and General Contractors handles contractor licensing or registration for Georgia. Check the licence is current in the official register, and ask for a certificate of insurance naming you before work starts.
+Do I need a permit in Georgia?
Metro Atlanta counties require land-disturbance approval once you exceed a set area of new impervious surface.
+Are prices different across Georgia?
Yes. Atlanta, Savannah, Augusta and Columbus set the top of the range because labour, disposal and permit costs are highest there. Rural parts of Georgia typically run 10 to 20 percent below those figures, unless the site is a long haul from the nearest plant or supply yard.
+How much does a asphalt driveway cost in Atlanta?
Around $6.96 to $14.90 per square foot installed, so a 600 square foot job in Atlanta runs roughly $4,173 – $8,942. Atlanta sits above the Georgia statewide average on labour, disposal and permit costs.
+Is it cheaper to resurface or replace a driveway in Georgia?
Resurfacing costs about 40 percent of a replacement in Georgia — $2.76 to $6.44 per square foot against $6.44 to $13.80. It is worth it only if the base is sound. Once more than a quarter of the surface shows base failure — recurring potholes, crumbling edges, soft flexing areas — replacement is the cheaper option over ten years.
+What does driveway repair cost in Georgia?
Crack filling runs $0.92 to $2.76 per linear foot and a pothole patch $110 to $368 in Georgia. Most contractors apply a minimum call-out of a few hundred dollars, so it pays to bundle repairs into one visit.
+Is it cheaper to build in a state bordering Georgia?
Alabama, South Carolina price below Georgia on the same specification. Near a state line that can be worth getting a quote from a crew based across it, as long as they are licensed to work in Georgia and the travel is short enough not to be priced back in.
+Are Georgia prices different in rural areas?
Yes — rural Georgia typically runs around 14 percent below the metro figure, roughly $5.54 to $11.87 per square foot installed. Long haul distance from the nearest asphalt plant can cancel that saving out.