Cost calculator
Asphalt Driveway Cost in Pennsylvania
Pennsylvania installed pricing runs $7.56 to $16.20 per square foot — about 8% above the national average. Enter your driveway size for a local estimate.
Your project
Tight, steep or long-haul sites cost more because the paver and trucks work slower.
Estimated Pennsylvania driveway cost
$3,629 – $7,776
- Area
- 480 sq ft
- Most likely price
- $5,184
- PA price per sq ft
- $7.56 – $16.20
- Asphalt required
- 8.7 tons
- Demolition included
- None
Prices are national planning averages. Asphalt is tied to crude oil and freight costs, so your local quote can land well outside this range. Always confirm with a paving contractor before budgeting. Most Pennsylvania contractors also apply a mobilisation minimum of roughly $2,160.
Asphalt driveway prices in Pennsylvania
A new asphalt driveway in Pennsylvania typically runs $7.56 to $16.20 per square foot installed, with most homeowners landing near $10.80. That puts PA about 8% above the national average.
Philadelphia and Pittsburgh pricing pulls the state above average; rural counties are cheaper.
A standard two-car driveway of 600 square feet therefore costs roughly $4,536 – $9,720 in Pennsylvania, and a 1,000 square foot driveway roughly $7,560 – $16,200.
Northern Freeze-Thaw build spec for Pennsylvania
Pennsylvania sits in a Northern Freeze-Thaw zone, where the pavement is attacked by hard freeze-thaw, heavy salting and steep hillside grading. Hard freeze-thaw with heavy winter salting.
That translates into a concrete specification: 6 to 8 inches of 2A modified stone, normally 2A modified crushed limestone, under the asphalt. On the mix side, PG 64-22 binder with a 9.5 mm wearing course.
The practical paving season in Pennsylvania is April through October. Plants close outside that window in most of the state, and asphalt placed on frozen or saturated subgrade will not compact properly no matter how good the crew is.
What moves the number most
Three things dominate: demolition of whatever is there now, base depth, and access. Tearing out old concrete adds roughly $3.24 per square foot in Pennsylvania. Difficult access — steep grades, tight gates, hand work around obstacles — adds about 25%.
Thickness matters less than people expect. Going from 2" to 3" of surface course adds only about 8% per inch to the total job, because mobilisation, grading and base are the same either way. It is nearly always worth paying for.
Getting quotes in Pennsylvania
Get three written quotes and make each one state compacted asphalt thickness, base material and base depth, and whether the price includes demolition and haul-off. A quote that only lists a square-foot price is not comparable to one that specifies 3" over 8" of processed gravel.
Book early in the season. Pennsylvania crews fill their schedules fast and late-season work gets rushed into cold weather, which is when compaction problems appear.
Pennsylvania driveway cost by size
Installed price range at $7.56-$16.20 per sq ft, 3" asphalt over base, no demolition.
| Driveway size | Typical dimensions | PA installed cost |
|---|---|---|
| 400 sq ft | 20 x 20 ft — one car | $3,024 – $6,480 |
| 600 sq ft | 20 x 30 ft — two cars | $4,536 – $9,720 |
| 1,000 sq ft | 20 x 50 ft — two cars plus turnaround | $7,560 – $16,200 |
| 1,500 sq ft | 12 x 125 ft — long rural drive | $11,340 – $24,300 |
| 2,500 sq ft | Large drive with parking apron | $18,900 – $40,500 |
Other paving work in Pennsylvania
| Work | PA price per sq ft |
|---|---|
| New asphalt driveway | $7.56 – $16.20 |
| Resurfacing / overlay | $3.24 – $7.56 |
| Tear-out and haul-off | $1.08 – $3.78 |
| Sealcoating (two coats) | $0.16 – $0.38 |
| Recycled asphalt millings | $2.16 – $5.40 |
Frequently asked questions
+How much does an asphalt driveway cost in Pennsylvania?
Between $7.56 and $16.20 per square foot installed, so a typical 600 sq ft two-car driveway runs $4,536 – $9,720. Demolition of an existing surface is extra.
+Is asphalt cheaper than concrete in Pennsylvania?
Yes — asphalt typically costs 40-50% less to install than concrete. Concrete lasts longer with less maintenance, but asphalt is faster to install, easier to repair and far more forgiving of ground movement.
+When is the best time to pave in Pennsylvania?
April through October. Booking early in that window gets you better crews and better compaction weather than a late-season rush job.
+How thick should the gravel base be for a driveway in Pennsylvania?
Because of Pennsylvania's hard freeze-thaw, heavy salting and steep hillside grading, contractors here specify 6 to 8 inches of 2A modified stone — typically 2A modified crushed limestone. Skimping on the base is the single most common cause of premature failure in a northern freeze-thaw climate.
+What type of asphalt mix is best for Pennsylvania?
In a Northern Freeze-Thaw zone, the right spec is PG 64-22 binder with a 9.5 mm wearing course. Ask any contractor to name the binder grade on the quote — if they cannot, they are buying whatever the plant has running that day.
+What goes wrong with driveways in Pennsylvania?
The local failure driver is hard freeze-thaw, heavy salting and steep hillside grading. That shows up as edge cracking and settlement within three to five years when the base is thin or drainage was never graded away from the slab.
+How long will an asphalt driveway last in Pennsylvania?
15-25 years with sealcoating every 3-5 years and prompt crack filling. In a Northern Freeze-Thaw zone, hard freeze-thaw, heavy salting and steep hillside grading shortens that to under 10 years if maintenance is skipped.