Cost calculator
Asphalt Driveway Cost in Utah
Utah installed pricing runs $7.00 to $15.00 per square foot — right at the national average. Enter your driveway size for a local estimate.
Your project
Tight, steep or long-haul sites cost more because the paver and trucks work slower.
Estimated Utah driveway cost
$3,360 – $7,200
- Area
- 480 sq ft
- Most likely price
- $4,800
- UT price per sq ft
- $7.00 – $15.00
- Asphalt required
- 8.7 tons
- Demolition included
- None
Prices are national planning averages. Asphalt is tied to crude oil and freight costs, so your local quote can land well outside this range. Always confirm with a paving contractor before budgeting. Most Utah contractors also apply a mobilisation minimum of roughly $2,000.
Asphalt driveway prices in Utah
A new asphalt driveway in Utah typically runs $7.00 to $15.00 per square foot installed, with most homeowners landing near $10.00. That puts UT right at the national average.
Fast-growing Wasatch Front demand has pulled Utah up to the national average.
A standard two-car driveway of 600 square feet therefore costs roughly $4,200 – $9,000 in Utah, and a 1,000 square foot driveway roughly $7,000 – $15,000.
Arid / Desert build spec for Utah
Utah sits in a Arid / Desert zone, where the pavement is attacked by real mountain frost depth combined with high-desert UV and salt-flat soils. Real frost depth along the mountains; 6" base minimum.
That translates into a concrete specification: 6 to 8 inches of untreated base course, normally untreated base course (crushed gravel), under the asphalt. On the mix side, PG 64-34 to cover both hot summers and cold winters.
The practical paving season in Utah is April through October. Plants close outside that window in most of the state, and asphalt placed on frozen or saturated subgrade will not compact properly no matter how good the crew is.
What moves the number most
Three things dominate: demolition of whatever is there now, base depth, and access. Tearing out old concrete adds roughly $3.00 per square foot in Utah. Difficult access — steep grades, tight gates, hand work around obstacles — adds about 25%.
Thickness matters less than people expect. Going from 2" to 3" of surface course adds only about 8% per inch to the total job, because mobilisation, grading and base are the same either way. It is nearly always worth paying for.
Getting quotes in Utah
Get three written quotes and make each one state compacted asphalt thickness, base material and base depth, and whether the price includes demolition and haul-off. A quote that only lists a square-foot price is not comparable to one that specifies 3" over 8" of processed gravel.
Book early in the season. Utah crews fill their schedules fast and late-season work gets rushed into cold weather, which is when compaction problems appear.
Utah driveway cost by size
Installed price range at $7.00-$15.00 per sq ft, 3" asphalt over base, no demolition.
| Driveway size | Typical dimensions | UT installed cost |
|---|---|---|
| 400 sq ft | 20 x 20 ft — one car | $2,800 – $6,000 |
| 600 sq ft | 20 x 30 ft — two cars | $4,200 – $9,000 |
| 1,000 sq ft | 20 x 50 ft — two cars plus turnaround | $7,000 – $15,000 |
| 1,500 sq ft | 12 x 125 ft — long rural drive | $10,500 – $22,500 |
| 2,500 sq ft | Large drive with parking apron | $17,500 – $37,500 |
Other paving work in Utah
| Work | UT price per sq ft |
|---|---|
| New asphalt driveway | $7.00 – $15.00 |
| Resurfacing / overlay | $3.00 – $7.00 |
| Tear-out and haul-off | $1.00 – $3.50 |
| Sealcoating (two coats) | $0.15 – $0.35 |
| Recycled asphalt millings | $2.00 – $5.00 |
Frequently asked questions
+How much does an asphalt driveway cost in Utah?
Between $7.00 and $15.00 per square foot installed, so a typical 600 sq ft two-car driveway runs $4,200 – $9,000. Demolition of an existing surface is extra.
+Is asphalt cheaper than concrete in Utah?
Yes — asphalt typically costs 40-50% less to install than concrete. Concrete lasts longer with less maintenance, but asphalt is faster to install, easier to repair and far more forgiving of ground movement.
+When is the best time to pave in Utah?
April through October. Booking early in that window gets you better crews and better compaction weather than a late-season rush job.
+How thick should the gravel base be for a driveway in Utah?
Because of Utah's real mountain frost depth combined with high-desert UV and salt-flat soils, contractors here specify 6 to 8 inches of untreated base course — typically untreated base course (crushed gravel). Skimping on the base is the single most common cause of premature failure in a arid / desert climate.
+What type of asphalt mix is best for Utah?
In a Arid / Desert zone, the right spec is PG 64-34 to cover both hot summers and cold winters. Ask any contractor to name the binder grade on the quote — if they cannot, they are buying whatever the plant has running that day.
+What goes wrong with driveways in Utah?
The local failure driver is real mountain frost depth combined with high-desert UV and salt-flat soils. That shows up as edge cracking and settlement within three to five years when the base is thin or drainage was never graded away from the slab.
+How long will an asphalt driveway last in Utah?
15-25 years with sealcoating every 3-5 years and prompt crack filling. In a Arid / Desert zone, real mountain frost depth combined with high-desert UV and salt-flat soils shortens that to under 10 years if maintenance is skipped.