Cost calculator
Missouri paver patio cost calculator
Paver installations in Missouri run $13 to $28 per square foot installed, against a national midpoint of $20. Competitive markets in both Kansas City and St. Louis hold prices near average.
Your project
Tumbled, permeable and large-format units carry a material premium.
Typical Missouri installed cost
$9,024
480 sq ft · $19 per sq ft
- Low estimate
- $6,317
- High estimate
- $13,536
- Missouri cost factor
- 94% of national
- Base depth required
- 4" compacted
- Materials share (~45%)
- $4,061
- Labour share (~40%)
- $3,610
- Base and prep (~15%)
- $1,354
Moderate freeze-thaw with clay subgrades that swell when wet. Paving season in Missouri is typically April through October. Figures are planning estimates — get three local quotes before committing.
The shareable link reopens this calculator with your exact inputs.
What drives paver cost in Missouri
Competitive markets in both Kansas City and St. Louis hold prices near average. That puts Missouri at roughly 94% of the national installed average for segmental paving.
Missouri sits in a Northern Freeze-Thaw zone, where paving is attacked by moderate freeze-thaw and clay subgrade that swells when saturated. Locally that means 6 inches of Type 5 crushed stone of Type 5 crushed limestone under a patio, and more under a driveway. That specification difference is a real line item: every extra inch of compacted base adds material, machine time and haul-off of the spoil it displaces.
Labour is about 40% of a paver job — far more than asphalt, which is machine-placed. That is why paver pricing tracks local wage rates much more closely than asphalt pricing does, and why the spread between states is wider here.
How to read a paver quote
A complete quote names the base depth, the bedding sand type, the joint sand product and the edge restraint. If any of those four are missing, the contractor has room to cut the part of the job you cannot see once the pavers are down.
Compare quotes on base depth first. A $19 per square foot quote with 8 inches of compacted base is cheaper over ten years than a $15 quote with 3 inches, because the second one gets rebuilt.
Hardscape costs across Missouri
Pricing inside Missouri is not uniform. The paver and hardscape market is set by the metro areas — Kansas City, St. Louis, Springfield and Columbia — where crew wages, disposal fees and permit costs all run above the state average. Rural counties in Missouri typically come in 10 to 20 percent below the metro figure on material-led work, and rather more than that on labour-led work, though long haul distances can claw some of it back.
Contractors working in Missouri are licensed or registered through the city or county building department (Missouri licenses locally). Before you sign anything, look the company up there and confirm the licence is current, then confirm liability insurance and workers' compensation directly with the insurer named on the certificate. A licence lookup takes two minutes and is the single most useful check a homeowner can make.
St. Louis County and Kansas City each license contractors and require a permit for driveway approaches.
What a paver patio costs in each part of Missouri
Inside Missouri, Kansas City is the market that sets the top of the range — crews there carry higher wages, disposal fees and permit costs, so a Kansas City job typically lands around 8 percent above the statewide figure. Work the same job out into rural Missouri and you can expect roughly 14 percent below it, provided the site is not a long haul from the nearest supply yard. Haul distance is the one thing that can reverse the discount entirely: past about 30 miles the truck time starts to eat the saving.
Quotes inside one metro still vary by 30 to 40 percent between contractors for the same scope, which is why the range above is a range. The cheap quote is usually cheap for a stated reason — thinner base, no compaction testing, no haul-off, or a crew squeezing you in at the end of the season. Ask each bidder to price the same written specification and the spread narrows dramatically.
Repair, relay or rebuild in Missouri
Pavers rarely need replacing — they need lifting and relaying. Settling, a dipped area by the downspout or a wavy edge are base problems, and the units themselves come up clean and go back down. Lift, re-base and relay runs about $8.46 to $15.04 per square foot in Missouri, against $13.16 to $28.20 for a new installation, and you keep the pavers.
That is the structural advantage over poured concrete and the reason a paver patio in Missouri survives moderate freeze-thaw and clay subgrade that swells when saturated: the joints move instead of cracking. Budget for re-sanding the joints every few years — at $0.85 to $1.88 per square foot it is the cheapest thing you will ever do to protect the installation, because open joints are how the bedding sand washes out and the settling starts.
How Missouri compares with neighbouring states
Kentucky, Tennessee, Arkansas, Oklahoma price below Missouri on the same specification, while Iowa, Illinois run higher. That matters if you live near the line: a contractor licensed in both states will often quote the cheaper labour market and travel, though anything more than about 45 minutes from their yard gets loaded back into the price.
Do not let the border tempt you past the licensing question. Whoever you hire must be licensed or registered to work in Missouri specifically — the city or county building department (Missouri licenses locally) is where you check that, and a licence in the neighbouring state does not carry over.
Missouri paver cost by project size
Installed, standard concrete pavers, patio base depth.
| Project | Area | Low | Typical | High |
|---|---|---|---|---|
| Small patio (10 × 12) | 120 sq ft | $1,579 | $2,256 | $3,384 |
| Standard patio (16 × 20) | 320 sq ft | $4,211 | $6,016 | $9,024 |
| Large patio (20 × 30) | 600 sq ft | $7,896 | $11,280 | $16,920 |
| Single driveway (12 × 40) | 480 sq ft | $8,122 | $11,731 | $18,048 |
| Double driveway (20 × 40) | 800 sq ft | $13,536 | $19,552 | $30,080 |
Missouri paver patio cost by metro area
Metro figures are the statewide installed range scaled by local labour, disposal and permit costs. Planning estimates, not quotes.
| Market | Installed per sq ft | 600 sq ft | 1,000 sq ft |
|---|---|---|---|
| Kansas City metro | $14.21 – $30.46 | $8,528 – $18,274 | $14,213 – $30,456 |
| St. Louis metro | $13.82 – $29.61 | $8,291 – $17,766 | $13,818 – $29,610 |
| Springfield metro | $13.55 – $29.05 | $8,133 – $17,428 | $13,555 – $29,046 |
| Columbia metro | $13.42 – $28.76 | $8,054 – $17,258 | $13,423 – $28,764 |
| Rural Missouri | $11.32 – $24.25 | $6,791 – $14,551 | $11,318 – $24,252 |
Missouri repair and maintenance prices
MO rates for work on an existing surface, before any mobilisation minimum.
| Job | Unit | MO price |
|---|---|---|
| Re-level a settled area | per sq ft | $5.64 – $11.28 |
| Replace cracked or stained units | per sq ft | $8.46 – $16.92 |
| Re-sand joints with polymeric sand | per sq ft | $0.85 – $1.88 |
| Seal the surface | per sq ft | $0.66 – $1.50 |
| Lift, re-base and relay | per sq ft | $8.46 – $15.04 |
| Full tear-out and new patio | per sq ft | $13.16 – $28.20 |
Paver cost in states bordering Missouri
Installed price per square foot, same specification, at each state's own rate.
| State | Installed per sq ft | 600 sq ft job |
|---|---|---|
| Iowa | $13.33 – $28.56 | $7,998 – $17,136 |
| Illinois | $16.02 – $34.32 | $9,612 – $20,592 |
| Kentucky | $12.99 – $27.84 | $7,794 – $16,704 |
| Tennessee | $12.66 – $27.12 | $7,596 – $16,272 |
| Arkansas | $11.98 – $25.68 | $7,188 – $15,408 |
| Oklahoma | $12.32 – $26.40 | $7,392 – $15,840 |
Frequently asked questions
+How much does a paver patio cost in Missouri?
Between $13 and $28 per square foot installed, with most homeowners landing near $19. A typical 320 square foot patio therefore runs about $6,016.
+Are paver driveways more expensive in Missouri?
Yes — $17 to $38 per square foot, because vehicles require 8 inches of compacted base instead of 4, and 80 mm pavers instead of 60 mm.
+When is the best time to install pavers in Missouri?
April through October. Moderate freeze-thaw with clay subgrades that swell when wet. Booking outside peak season often gets you a better rate, since crews price scarcity in the middle of the season.
+Are pavers cheaper than an asphalt driveway?
No. Asphalt installs at a fraction of the square-foot cost, but pavers last 25-50 years against 15-20 for asphalt and individual units can be lifted and reset. Over the full lifecycle the gap narrows considerably.
+What is not included in a typical quote?
Demolition of an existing surface, drainage work, permits, retaining or step work, and lighting. Add demolition above to see how it moves the total.
+How deep should the paver base be in Missouri?
Plan on 6 inches of Type 5 crushed stone of Type 5 crushed limestone for a patio, and add a further two to four inches for a driveway. Missouri's moderate freeze-thaw and clay subgrade that swells when saturated punishes shallow bases faster than anything else on the job.
+Do pavers handle Missouri's climate better than asphalt?
In a Northern Freeze-Thaw zone, generally yes. Segmental paving flexes with ground movement instead of cracking, and individual units can be lifted and reset where moderate freeze-thaw and clay subgrade that swells when saturated has caused settlement.
+How accurate are these numbers?
They are national averages adjusted by a Missouri labour and material factor, not quotes. Site access, slope, soil condition and pattern complexity each move the real number by 10% or more.
+Do I need a licensed hardscape contractor in Missouri?
The city or county building department (Missouri licenses locally) handles contractor licensing or registration for Missouri. Check the licence is current in the official register, and ask for a certificate of insurance naming you before work starts.
+Do I need a permit in Missouri?
St. Louis County and Kansas City each license contractors and require a permit for driveway approaches.
+Are prices different across Missouri?
Yes. Kansas City, St. Louis, Springfield and Columbia set the top of the range because labour, disposal and permit costs are highest there. Rural parts of Missouri typically run 10 to 20 percent below those figures, unless the site is a long haul from the nearest plant or supply yard.
+How much does a paver patio cost in Kansas City?
Around $14.21 to $30.46 per square foot installed, so a 600 square foot job in Kansas City runs roughly $8,528 – $18,274. Kansas City sits above the Missouri statewide average on labour, disposal and permit costs.
+Can a settled paver patio in Missouri be repaired rather than replaced?
Almost always. Lifting the affected area, correcting the base and relaying the same units costs about $8.46 to $15.04 per square foot in Missouri, well under the $13.16 to $28.20 of a new installation, and the pavers are reused.
+What does paver repair cost in Missouri?
Re-levelling a settled area costs $5.64 to $11.28 per square foot in Missouri and re-sanding joints $0.85 to $1.88. Most contractors apply a minimum call-out, so bundle the work.
+Is it cheaper to build in a state bordering Missouri?
Kentucky, Tennessee, Arkansas, Oklahoma price below Missouri on the same specification. Near a state line that can be worth getting a quote from a crew based across it, as long as they are licensed to work in Missouri and the travel is short enough not to be priced back in.
+Are Missouri prices different in rural areas?
Yes — rural Missouri typically runs around 14 percent below the metro figure, roughly $11.32 to $24.25 per square foot installed. Long haul distance from the nearest supply yard can cancel that saving out.