Cost calculator
Wyoming paver patio cost calculator
Paver installations in Wyoming run $16 to $34 per square foot installed, against a national midpoint of $20. The lowest population density in the country means mobilisation is a real share of any small job.
Your project
Tumbled, permeable and large-format units carry a material premium.
Typical Wyoming installed cost
$10,752
480 sq ft · $22 per sq ft
- Low estimate
- $7,526
- High estimate
- $16,128
- Wyoming cost factor
- 112% of national
- Base depth required
- 4" compacted
- Materials share (~45%)
- $4,838
- Labour share (~40%)
- $4,301
- Base and prep (~15%)
- $1,613
High altitude, deep frost and wind scour; base depth and drainage decide the lifespan. Paving season in Wyoming is typically June through September. Figures are planning estimates — get three local quotes before committing.
The shareable link reopens this calculator with your exact inputs.
What drives paver cost in Wyoming
The lowest population density in the country means mobilisation is a real share of any small job. That puts Wyoming at roughly 112% of the national installed average for segmental paving.
Wyoming sits in a Northern Freeze-Thaw zone, where paving is attacked by extreme wind, deep frost and haul distances measured in hours. Locally that means 8 to 12 inches of crushed base course of crushed base course (local gravel pit) under a patio, and more under a driveway. That specification difference is a real line item: every extra inch of compacted base adds material, machine time and haul-off of the spoil it displaces.
Labour is about 40% of a paver job — far more than asphalt, which is machine-placed. That is why paver pricing tracks local wage rates much more closely than asphalt pricing does, and why the spread between states is wider here.
How to read a paver quote
A complete quote names the base depth, the bedding sand type, the joint sand product and the edge restraint. If any of those four are missing, the contractor has room to cut the part of the job you cannot see once the pavers are down.
Compare quotes on base depth first. A $22 per square foot quote with 8 inches of compacted base is cheaper over ten years than a $18 quote with 3 inches, because the second one gets rebuilt.
Hardscape costs across Wyoming
Pricing inside Wyoming is not uniform. The paver and hardscape market is set by the metro areas — Cheyenne, Casper and Gillette — where crew wages, disposal fees and permit costs all run above the state average. Rural counties in Wyoming typically come in 10 to 20 percent below the metro figure on material-led work, and rather more than that on labour-led work, though long haul distances can claw some of it back.
Contractors working in Wyoming are licensed or registered through the city or county building department (Wyoming licenses locally). Before you sign anything, look the company up there and confirm the licence is current, then confirm liability insurance and workers' compensation directly with the insurer named on the certificate. A licence lookup takes two minutes and is the single most useful check a homeowner can make.
Permits are issued locally, and wind-driven freeze-thaw makes base depth the critical specification.
What a paver patio costs in each part of Wyoming
Inside Wyoming, Cheyenne is the market that sets the top of the range — crews there carry higher wages, disposal fees and permit costs, so a Cheyenne job typically lands around 8 percent above the statewide figure. Work the same job out into rural Wyoming and you can expect roughly 14 percent below it, provided the site is not a long haul from the nearest supply yard. Haul distance is the one thing that can reverse the discount entirely: past about 30 miles the truck time starts to eat the saving.
Quotes inside one metro still vary by 30 to 40 percent between contractors for the same scope, which is why the range above is a range. The cheap quote is usually cheap for a stated reason — thinner base, no compaction testing, no haul-off, or a crew squeezing you in at the end of the season. Ask each bidder to price the same written specification and the spread narrows dramatically.
Repair, relay or rebuild in Wyoming
Pavers rarely need replacing — they need lifting and relaying. Settling, a dipped area by the downspout or a wavy edge are base problems, and the units themselves come up clean and go back down. Lift, re-base and relay runs about $10.08 to $17.92 per square foot in Wyoming, against $15.68 to $33.60 for a new installation, and you keep the pavers.
That is the structural advantage over poured concrete and the reason a paver patio in Wyoming survives extreme wind, deep frost and haul distances measured in hours: the joints move instead of cracking. Budget for re-sanding the joints every few years — at $1.01 to $2.24 per square foot it is the cheapest thing you will ever do to protect the installation, because open joints are how the bedding sand washes out and the settling starts.
How Wyoming compares with neighbouring states
Montana, South Dakota, Nebraska, Colorado, Utah, Idaho price below Wyoming on the same specification. That matters if you live near the line: a contractor licensed in both states will often quote the cheaper labour market and travel, though anything more than about 45 minutes from their yard gets loaded back into the price.
Do not let the border tempt you past the licensing question. Whoever you hire must be licensed or registered to work in Wyoming specifically — the city or county building department (Wyoming licenses locally) is where you check that, and a licence in the neighbouring state does not carry over.
Wyoming paver cost by project size
Installed, standard concrete pavers, patio base depth.
| Project | Area | Low | Typical | High |
|---|---|---|---|---|
| Small patio (10 × 12) | 120 sq ft | $1,882 | $2,688 | $4,032 |
| Standard patio (16 × 20) | 320 sq ft | $5,018 | $7,168 | $10,752 |
| Large patio (20 × 30) | 600 sq ft | $9,408 | $13,440 | $20,160 |
| Single driveway (12 × 40) | 480 sq ft | $9,677 | $13,978 | $21,504 |
| Double driveway (20 × 40) | 800 sq ft | $16,128 | $23,296 | $35,840 |
Wyoming paver patio cost by metro area
Metro figures are the statewide installed range scaled by local labour, disposal and permit costs. Planning estimates, not quotes.
| Market | Installed per sq ft | 600 sq ft | 1,000 sq ft |
|---|---|---|---|
| Cheyenne metro | $16.93 – $36.29 | $10,161 – $21,773 | $16,934 – $36,288 |
| Casper metro | $16.46 – $35.28 | $9,878 – $21,168 | $16,464 – $35,280 |
| Gillette metro | $16.15 – $34.61 | $9,690 – $20,765 | $16,150 – $34,608 |
| Rural Wyoming | $13.48 – $28.90 | $8,091 – $17,338 | $13,485 – $28,896 |
Wyoming repair and maintenance prices
WY rates for work on an existing surface, before any mobilisation minimum.
| Job | Unit | WY price |
|---|---|---|
| Re-level a settled area | per sq ft | $6.72 – $13.44 |
| Replace cracked or stained units | per sq ft | $10.08 – $20.16 |
| Re-sand joints with polymeric sand | per sq ft | $1.01 – $2.24 |
| Seal the surface | per sq ft | $0.78 – $1.79 |
| Lift, re-base and relay | per sq ft | $10.08 – $17.92 |
| Full tear-out and new patio | per sq ft | $15.68 – $33.60 |
Paver cost in states bordering Wyoming
Installed price per square foot, same specification, at each state's own rate.
| State | Installed per sq ft | 600 sq ft job |
|---|---|---|
| Montana | $14.84 – $31.80 | $8,904 – $19,080 |
| South Dakota | $14.34 – $30.72 | $8,604 – $18,432 |
| Nebraska | $12.99 – $27.84 | $7,794 – $16,704 |
| Colorado | $15.34 – $32.88 | $9,204 – $19,728 |
| Utah | $14.00 – $30.00 | $8,400 – $18,000 |
| Idaho | $14.34 – $30.72 | $8,604 – $18,432 |
Frequently asked questions
+How much does a paver patio cost in Wyoming?
Between $16 and $34 per square foot installed, with most homeowners landing near $22. A typical 320 square foot patio therefore runs about $7,168.
+Are paver driveways more expensive in Wyoming?
Yes — $20 to $45 per square foot, because vehicles require 8 inches of compacted base instead of 4, and 80 mm pavers instead of 60 mm.
+When is the best time to install pavers in Wyoming?
June through September. High altitude, deep frost and wind scour; base depth and drainage decide the lifespan. Booking outside peak season often gets you a better rate, since crews price scarcity in the middle of the season.
+Are pavers cheaper than an asphalt driveway?
No. Asphalt installs at a fraction of the square-foot cost, but pavers last 25-50 years against 15-20 for asphalt and individual units can be lifted and reset. Over the full lifecycle the gap narrows considerably.
+What is not included in a typical quote?
Demolition of an existing surface, drainage work, permits, retaining or step work, and lighting. Add demolition above to see how it moves the total.
+How deep should the paver base be in Wyoming?
Plan on 8 to 12 inches of crushed base course of crushed base course (local gravel pit) for a patio, and add a further two to four inches for a driveway. Wyoming's extreme wind, deep frost and haul distances measured in hours punishes shallow bases faster than anything else on the job.
+Do pavers handle Wyoming's climate better than asphalt?
In a Northern Freeze-Thaw zone, generally yes. Segmental paving flexes with ground movement instead of cracking, and individual units can be lifted and reset where extreme wind, deep frost and haul distances measured in hours has caused settlement.
+How accurate are these numbers?
They are national averages adjusted by a Wyoming labour and material factor, not quotes. Site access, slope, soil condition and pattern complexity each move the real number by 10% or more.
+Do I need a licensed hardscape contractor in Wyoming?
The city or county building department (Wyoming licenses locally) handles contractor licensing or registration for Wyoming. Check the licence is current in the official register, and ask for a certificate of insurance naming you before work starts.
+Do I need a permit in Wyoming?
Permits are issued locally, and wind-driven freeze-thaw makes base depth the critical specification.
+Are prices different across Wyoming?
Yes. Cheyenne, Casper and Gillette set the top of the range because labour, disposal and permit costs are highest there. Rural parts of Wyoming typically run 10 to 20 percent below those figures, unless the site is a long haul from the nearest plant or supply yard.
+How much does a paver patio cost in Cheyenne?
Around $16.93 to $36.29 per square foot installed, so a 600 square foot job in Cheyenne runs roughly $10,161 – $21,773. Cheyenne sits above the Wyoming statewide average on labour, disposal and permit costs.
+Can a settled paver patio in Wyoming be repaired rather than replaced?
Almost always. Lifting the affected area, correcting the base and relaying the same units costs about $10.08 to $17.92 per square foot in Wyoming, well under the $15.68 to $33.60 of a new installation, and the pavers are reused.
+What does paver repair cost in Wyoming?
Re-levelling a settled area costs $6.72 to $13.44 per square foot in Wyoming and re-sanding joints $1.01 to $2.24. Most contractors apply a minimum call-out, so bundle the work.
+Is it cheaper to build in a state bordering Wyoming?
Montana, South Dakota, Nebraska, Colorado, Utah, Idaho price below Wyoming on the same specification. Near a state line that can be worth getting a quote from a crew based across it, as long as they are licensed to work in Wyoming and the travel is short enough not to be priced back in.
+Are Wyoming prices different in rural areas?
Yes — rural Wyoming typically runs around 14 percent below the metro figure, roughly $13.48 to $28.90 per square foot installed. Long haul distance from the nearest supply yard can cancel that saving out.